Try re-threading the machine; make sure the thread goes through all guides.
may be burrs in the needle's eye, on the thread guides, needle plate or
the hook. Replace the needle and try buffing the thread guides and
needle plate. Buffing may alter the timing, so it's a good idea to
replace a damaged hook.
it dries out faster, the hook needs frequent lubrication. The hook
assembly should be lubricated every 4-8 hours of machine running time.
Needle to small
You may have to change to a larger needle
Too much Adhesive spray
should be using only Embroidery designed adhesive sprays, never over
use them. Too much adhesive build up on the needle can cause them to
drag and break threads. If this is happening you should examine the way
you use your adhesive spray
your machine isn't timed properly, it can cause many probems in
addition to thread breaks. Such as broken needles, poor stitching or
sometimes no stitching.
can become brittle with age and long exposure to light, air and heat.
You should store your thread in a cool, dark place to lengthen shelf
bruised cone of thread can occur if the thread falls on the floor,
causing the lower winding of thread to loosen and catch as the thread
spools off. You can take off the affected part of the thread or replace
Some of the designs increase the stress on thread. You should lower the machine speed as needed
Lint build up
lint build up on the tension discs, needle plate or bobbin cases can
cause breakage. These areas should be cleaned frequently with air or a
can happen after the needle hits a very hard object such as a Hoop,
needle plate or the hook. If this happens you have to replace the needle
and check for burrs and the timing.
the tension is too tight, it can cause pulling, puckering and thread
stress. If the thread is too loose it can cause the thread to pile up
and loop. You have to adjust the tensions to achieve a flat smooth look.
Using Tape for loose ends
Using tape can leave a residue and this can cause friction and thread breakage.
Holding the thread
you hold the loose end of the thread when you start up the machine and
you are pulling the thread too tight, it can cause the needle to bend or
break and can also cause the thread to break.
Stitches form wrong or not at all
Retaining finger in wrong position
loop can not form
the bobbin hook won't catch the loop
Needle position is incorrect
can cause the timing to be off
Wrong Needle Size
in relation to the thread and this can make it difficult for loops to form
Thread is to tight or to loose
causes irregular loops to form
Timing is incorrect
can cause the bobbin hook to not catch the loop
will bend and eventually break, replace
damage to needle and hook and poor stitch quality
Holding thread during startup
can bend the needle and break the thread
Needle is inserted wrong
insert all the way up the needle bar shaft and needle screw is tight
Needle cuts holes in garment
difficult to pierce garment causing tearing
Needle point is wrong type
wrong point can damage some fabrics, try a ballpoint
Needle to large
can stretch fabrics
Fabrics are to delicate
may have to use a topping
The design is out of register
Garment is hooped to loosley
re-hoop but do not stretch fabric
The fabric is unstable
you may have to use a heavier backing
Garment is puckering
Tensions to tight for a particular thread or garment
Too many stitches in an area
These are some of the normal problems you may experience during the Embroidery Process.
If a problem persists, we recommend that you contact